
9
BP-200 SINGLE CHANNEL WIRELESS BELTPACK.
The included NiMh batteries has a shelf discharging time around 2 month. So it is
imperative to check the battery status before use: switch ON the unit and then, press shortly
the ON switch. As a general rule, charge the unit before using the system.
4. SPECIAL OPERATIONS
In order to set-up some of the wireless beltpack possibilities, the unit must be opened
removing the two external screws of its rear panel.
NOTE: This type of operations takes place with the unit is opened; the best thing should be to
carry it out by a qualified technician. Care must be taken to avoid short circuit between battery
holders, etc.
DANGER: Before opening the unit, turn it off. Use of protective glasses when operating
batteries.
CAUTION: Protect the wireless beltpack from the rain and moisture, mostly if it is open. If liquid
is spilled into the unit, disconnect it from the mains and consult a qualified service technician.
ACTIVATING THE MICROPHONE PHANTOM POWER
The microphone PHANTOM power could be activated or disabled with
an internal jumper (JP2/ PHANTOM). With this jumper removed, the
phantom power is disabled and with this jumper placed the phantom power
is activated.
If an electret microphone is used, the PHANTOM power must be
enabled and if a dynamic microphone is used, the PHANTOM power must
be disabled. The microphone PHANTOM power is 9 VDC.
It is convenient to place the jumper over one pin for future use.
CANCELLING THE BUZZER
The buzzer can be disabled definitely by removing a jumper
JP1/BUZZER located near the buzzer on the upper-right side of the unit.
This jumper defeats the actions of the buzzer key and remote buzzer
key. It is convenient to place the jumper over one pin for future use.
Disabling the buzzer guarantees no CALL sounds in any circumstance,
as desired in theatre or any other public performance.
CHANGING THE BATTERIES
The wireless case includes three NiMh (1,2 V) batteries of size AAA and capacity of 900 -
1000 mA/h. In the case it must be replaced one battery, replaces all at the same time, by three
equal batteries.
The beltpack can work in case of necessity with three alkaline batteries (1,5 V), size AAA,
but it considers that the batteries cannot be charged.
Don’t try to use the unit with no batteries or batteries in bad condition; the unit can be
damage. When necessary, the unit can be used when charging at the same time. You can
either plug the charger when the unit is ON or switch ON the unit when in charging.
NOTE ON ENVIRONMENTAL PROTECTION:
Commenti su questo manuale