8
The main function of this switch is to select the operation channel you want to
communicate. Selected channel is indicated on the indicator lamps A/B and the OLED
Display: . Pressing this switch, if it was selected, deselected and vice versa, with
the condition that should always be selected a channel (A or B, or both at the same
time), so if you only have selected A and press A, not deselect as always should be
selected at least one channel. Channel selection affects the beltpack functions as
described:
MIC: The beltpack mic signal is feed to the selected channel indicated by the lamps. You
can adjust your mic level by menu or by pressing the mic switch and change its gain with
the up-down arrows.
LISTENING The listening channel depends also of the selected channel indicated
by the lamps and by the OLED display: . By selecting AB, you can listen both
channels simultaneously. A balance listening between channels is allowed in each of the
3 possible selections A, AB and B. By using this balance, you can listening the opposite
channel at a small, say 20 % level, helping management of both channel crews at a time.
CALL The sending Call channel is the indicated on the lamps and in the OLED display.
When AB is selected, a Call is sent to both channels. The receiving channel Call is also
shown on the AB lamps by flashing accordingly. As the selected channel is obviously not
automated, you must go to that channel if you are in the opposite channel in order to
communicate with him.
3.4 STAGE ANOUNCE (SA) KEY
With this function, you can send a message to
the PA (Public Address) system from your beltpack
at any time.
Press and hold the Channel Select switch and when the AB lamps
flashes (wait 2 seconds), start your message from the headset
microphone. When done, release the switch.
On the WBS-202 base station, the front panel SA led will glow for the time you are
depressing this switch and the message is carried out from the SA output to the external
PA equipment. This function is very useful for timing events, fire alarms, or general
announces.
Intercom mic signal is not interrupted in this mode and remains in the selected
channel.
3.5 CALL SWITCH
switch is
signal is
and to
which it
station.
The call signal makes the LED associated with
the switch to start blinking; the OLED display
WBP-212 WIRELESS DUAL CHANNEL MANAGER
(12 pagine)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale